What Are the Steps Required to Clip with GIMP?.Tune in if you are ready to make mind boggling edits to the photo of your choice using GIMP! In this blog, I will take you on a step-by-step track on clipping with GIMP, explain why clipping is such a useful tool, and answer some of the most common questions regarding GIMP and its clipping feature. One such useful function of GIMP is the clipping function.Ĭlipping with GIMP can be done very easily by first creating a new layer group, inserting the clipping mask, compiling the photos, adding the layer masks, and exporting the final product. You can perform a number of useful edits with GIMP, be it just a simple glow up of your favorite picture or a studio poster of a flagship event you are organizing. If you are an avid photo editor, you must have heard of the GNU Image Manipulation Program (GIMP), which is a free cross platform image editing software used by professionals and amateurs all around the globe. Of course, you can just as well link only the mask layers and move them while leaving the image layers static, or any combination of linking.Easy Steps to Learn Clipping With Gimp You can now move the image layers while the static mask layers and the modified layer modes do the hard work. Link only the image layers across the groups that you wish to move against the masks. You do not need to change the layer mode of the layer group itself for this.ģ. Put each image-layer/mask-layer couple into its own layer group.Ī layer group isolates the scope of the layer modes and prevents them from acting on every visible layer lower in the entire project, grouped or not, so that you do not get undesired additional darkening. Set the mode of the image layers from Normal to Darken only.Ģ. Make the mask layers fully white where the image content should be visible, and transparent everywhere else.Īrrange each mask layer below its corresponding image layer. Do not use masks, use separate image layers that act like masks. So every suggestion that made me somehow store the mask for later would cause unacceptable tedium. Not only did I need to move an image against the bits where it should be visible, I needed to do it for multiple layers at once, and I needed it to be non-destructive so that I could move and adjust until happy. I know this is an old topic but it still ranks rather high in Google search results. You could probably do something by saving the selection too and I’m sure there are many more approaches you could take… but I’ve not done it that way… Rather than doing the"selection" thing you could also just select the mask in the layer browser (then select all) ,copy it and then paste it to a new image or new layer… make your changes then re-select the layer mask, copy it back in and hit the “anchor” button to "un-float"it into the layer mask Then restore the mask using the same process as above,(but choose the original layer rather than the create a new one, obviously!) Now either remove or disable/hide the mask for the layer you want to move, move it around to where you want… Try storing the mask, moving the layer then restoring the mask…ģ) layer->mask->add layer mask (choose the “from selection” option) To leave the mask and move the image… is a bit more roundabout as far as I know… Moving the mask independantly is simple… select the mask and use the move tool…
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |